On my Dell XPS 16 i get this error when burning cds, dvds sometimes burn at 0.3x, other times they fail. I have used other burning programs and tried direct burning from cli with same result. Drive and media work fine under win7, so the problem is not hardware.<br>
Surfed<br><br>Devices<br>-----------------------<br>CDEmu Virt. CD/DVD-ROM 1.10 (/dev/sr1, CD-ROM, DVD-ROM) [DVD-ROM, CD-ROM] [None] [%7]<br>HL-DT-ST DVD+-RW GA11N A102 (/dev/sr0, CD-R, CD-RW, CD-ROM, DVD-ROM, DVD-R, DVD-RW, DVD-R DL, DVD+R, DVD+RW, DVD+R DL) [DVD-ROM, DVD-R Sequential, DVD-R Dual Layer Sequential, DVD-RAM, DVD-RW Restricted Overwrite, DVD-RW Sequential, DVD+RW, DVD+R, DVD+R Dual Layer, CD-ROM, CD-R, CD-RW] [SAO, TAO, RAW, SAO/R96P, SAO/R96R, RAW/R16, RAW/R96P, RAW/R96R, Restricted Overwrite] [%7]<br>
<br>K3b::IsoImager<br>-----------------------<br>mkisofs print size result: 47958 (98217984 bytes)<br><br>System<br>-----------------------<br>K3b Version: 1.69.0<br>KDE Version: 4.3.95 (KDE 4.3.95 (KDE 4.4 RC2))<br>QT Version: 4.6.1<br>
Kernel: 2.6.33-rc4-rc4<br><br>Used versions<br>-----------------------<br>mkisofs: 1.1.10<br>cdrecord: 1.1.10<br><br>cdrecord<br>-----------------------<br>scsidev: '/dev/sr0'<br>devname: '/dev/sr0'<br>
scsibus: -2 target: -2 lun: -2<br>Linux sg driver version: 3.5.27<br>Wodim version: 1.1.10<br>SCSI buffer size: 64512<br>Beginning DMA speed test. Set CDR_NODMATEST environment variable if device<br>communication breaks or freezes immediately after that.<br>
TOC Type: 3 = CD-ROM XA mode 2<br>Driveropts: 'burnfree'<br>Device type : Removable CD-ROM<br>Version : 5<br>Response Format: 2<br>Capabilities : <br>Vendor_info : 'HL-DT-ST'<br>Identification : 'DVD+-RW GA11N '<br>
Revision : 'A102'<br>Device seems to be: Generic mmc2 DVD-R/DVD-RW.<br>Current: 0x0009 (CD-R)<br>Profile: 0x0012 (DVD-RAM) <br>Profile: 0x0011 (DVD-R sequential recording) <br>Profile: 0x0015 (DVD-R/DL sequential recording) <br>
Profile: 0x0014 (DVD-RW sequential recording) <br>Profile: 0x0013 (DVD-RW restricted overwrite) <br>Profile: 0x001A (DVD+RW) <br>Profile: 0x001B (DVD+R) <br>Profile: 0x002B (DVD+R/DL) <br>Profile: 0x0010 (DVD-ROM) <br>Profile: 0x0009 (CD-R) (current)<br>
Profile: 0x000A (CD-RW) <br>Profile: 0x0008 (CD-ROM) <br>Profile: 0x0002 (Removable disk) <br>Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).<br>Driver flags : MMC-3 SWABAUDIO BURNFREE <br>Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R<br>
Drive buf size : 1053696 = 1029 KB<br>Drive DMA Speed: 15215 kB/s 86x CD 10x DVD<br>FIFO size : 4194304 = 4096 KB<br>Speed set to 2822 KB/s<br>Track 01: data 93 MB <br>Total size: 107 MB (10:39.46) = 47960 sectors<br>
Lout start: 107 MB (10:41/35) = 47960 sectors<br>Current Secsize: 2048<br>ATIP info from disk:<br> Indicated writing power: 5<br> Is not unrestricted<br> Is not erasable<br> Disk sub type: Medium Type A, high Beta category (A+) (3)<br>
ATIP start of lead in: -11634 (97:26/66)<br> ATIP start of lead out: 359846 (79:59/71)<br>Disk type: Short strategy type (Phthalocyanine or similar)<br>Manuf. index: 3<br>Manufacturer: CMC Magnetics Corporation<br>
Blocks total: 359846 Blocks current: 359846 Blocks remaining: 311886<br>Starting to write CD/DVD at speed 16.0 in real TAO mode for multi session.<br>Last chance to quit, starting real write in 2 seconds.<br> 1 seconds.<br>
0 seconds. Operation starts.<br>Waiting for reader process to fill input buffer ... input buffer ready.<br>Performing OPC...<br>Starting new track at sector: 0<br>Track 01: 0 of 93 MB written.<br>Track 01: 1 of 93 MB written (fifo 100%) [buf 99%] 0.4x.<br>
Errno: 5 (Input/output error), write_g1 scsi sendcmd: no error<br>CDB: 2A 00 00 00 02 0F 00 00 1F 00<br>status: 0x2 (CHECK CONDITION)<br>Sense Bytes: 70 00 05 00 00 00 00 0A 2A 30 02 80 21 02 00 00<br>Sense Key: 0x5 Illegal Request, Segment 0<br>
Sense Code: 0x21 Qual 0x02 (invalid address for write) Fru 0x0<br>Sense flags: Blk 0 (not valid) <br>cmd finished after 0.003s timeout 40s<br>/usr/bin/wodim: The current problem looks like a buffer underrun.<br>/usr/bin/wodim: It looks like 'driveropts=burnfree' does not work for this drive.<br>
/usr/bin/wodim: Please report.<br>/usr/bin/wodim: Make sure that you are root, enable DMA and check your HW/OS set up.<br>write track data: error after 1079296 bytes<br>Writing time: 25.131s<br>Average write speed 25.5x.<br>
Min drive buffer fill was 99%<br>Fixating...<br>Fixating time: 27.574s<br>/usr/bin/wodim: fifo had 81 puts and 18 gets.<br>/usr/bin/wodim: fifo was 0 times empty and 7 times full, min fill was 92%.<br><br>cdrecord command:<br>
-----------------------<br>/usr/bin/wodim -v gracetime=2 dev=/dev/sr0 speed=16 -tao driveropts=burnfree -multi fs=4m -xa -tsize=47958s -<br><br>mkisofs<br>-----------------------<br>47958<br>I: -input-charset not specified, using utf-8 (detected in locale settings)<br>
1.07% done, estimate finish Thu Jan 21 16:25:41 2010<br> 2.11% done, estimate finish Thu Jan 21 16:24:55 2010<br> 3.14% done, estimate finish Thu Jan 21 16:24:39 2010<br> 4.18% done, estimate finish Thu Jan 21 16:24:31 2010<br>
5.24% done, estimate finish Thu Jan 21 16:30:48 2010<br><br>mkisofs calculate size command:<br>-----------------------<br>/usr/bin/genisoimage -gui -graft-points -print-size -quiet -volid Antonio Vivaldi -volset -appid K3B THE CD KREATOR (C) 1998-2009 SEBASTIAN TRUEG -publisher -preparer -sysid LINUX -volset-size 1 -volset-seqno 1 -sort /tmp/kde-sascha/k3bRt8318.tmp -rational-rock -hide-list /tmp/kde-sascha/k3bmI8318.tmp -joliet -joliet-long -hide-joliet-list /tmp/kde-sascha/k3bKr8318.tmp -no-cache-inodes -full-iso9660-filenames -iso-level 3 -path-list /tmp/kde-sascha/k3bwG8318.tmp<br>
<br>mkisofs command:<br>-----------------------<br>/usr/bin/genisoimage -gui -graft-points -volid Antonio Vivaldi -volset -appid K3B THE CD KREATOR (C) 1998-2009 SEBASTIAN TRUEG -publisher -preparer -sysid LINUX -volset-size 1 -volset-seqno 1 -sort /tmp/kde-sascha/k3bBz8318.tmp -rational-rock -hide-list /tmp/kde-sascha/k3bMW8318.tmp -joliet -joliet-long -hide-joliet-list /tmp/kde-sascha/k3bfx8318.tmp -no-cache-inodes -full-iso9660-filenames -iso-level 3 -path-list /tmp/kde-sascha/k3bgB8318.tmp<br>
<br>