Hello,<br>I'm trying to setup my UPS using the "megatec" driver, but for now without success. from what I understood, the UPS should be connected to serial port (despite being an USB UPS), so I did i.<br><br>
sudo upsdrvctl start<br>Network UPS Tools - UPS driver controller 2.0.5<br>Network UPS Tools - Megatec protocol driver 1.5 (2.0.5)<br>Carlos Rodrigues (c) 2003-2006<br><br>Megatec protocol UPS not detected.<br>Driver failed to start (exit status=1)
<br><br>-----<br><br>sudo /lib/nut/megatec -DD -a mustek<br>Network UPS Tools - Megatec protocol driver 1.5 (2.0.5)<br>Carlos Rodrigues (c) 2003-2006<br><br>debug level is '2'<br>Starting UPS detection process...<br>
Attempting to detect the UPS...<br>Sending "Q1" command...<br>Wrong answer to "Q1" command.<br>Attempting to detect the UPS...<br>Sending "Q1" command...<br>Wrong answer to "Q1" command.
<br>Attempting to detect the UPS...<br>Sending "Q1" command...<br>Wrong answer to "Q1" command.<br>Attempting to detect the UPS...<br>Sending "Q1" command...<br>Wrong answer to "Q1" command.
<br>Attempting to detect the UPS...<br>Sending "Q1" command...<br>Wrong answer to "Q1" command.<br>5 out of 5 detection attempts failed (minimum failures: 2).<br>Megatec protocol UPS not detected.<br><br>
----<br><br>Any help would be appreciated.<br>Igal.<br><br><br>