<div>Hi,<br></div><div>I have a Liebert POWERSURE PSP connected via USB. Cleanly built and installed from source nut-2.4.3.tar.gz</div><div></div><div> using kernel 2.6.30.5</div><div>#cat /proc/bus/usb</div><div>T: Bus=02 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 2 Spd=1.5 MxCh= 0<br>
D: Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1<br>P: Vendor=10af ProdID=0003 Rev= 0.00<br>S: Manufacturer=Liebert<br>S: Product=Liebert PSP 350 FW: 02<br>S: SerialNumber=0404200536BT019<br>C:* #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr= 20mA<br>
I:* If#= 0 Alt= 0 #EPs= 1 Cls=03(HID ) Sub=00 Prot=00 Driver=usbhid<br>E: Ad=81(I) Atr=03(Int.) MxPS= 8 Ivl=248ms</div><div><br># ./upsdrvctl start<br>Network UPS Tools - UPS driver controller 2.4.3<br>Network UPS Tools - Generic HID driver 0.34 (2.4.3)<br>
USB communication driver 0.31<br>This Liebert device (10af:0003) is not (or perhaps not yet) supported<br>by usbhid-ups. Please make sure you have an up-to-date version of NUT. If<br>this does not fix the problem, try running the driver with the<br>
'-x productid=0003' option. Please report your results to the NUT user's<br>mailing list <<a href="mailto:nut-upsuser@lists.alioth.debian.org">nut-upsuser@lists.alioth.debian.org</a>>.<br><br>No matching HID UPS found<br>
Driver failed to start (exit status=1)<br><br></div><div>i changed ups.conf from:</div><div>driver = usbhid-ups</div><div>to</div><div>driver = usbhid-ups -x productid=0003</div><div></div><div>I recieve the same message as above. Perhaps i'm making an obvious mistake somewhere?</div>