<div dir="ltr"><div><div><div>Hi,<br><br></div>I have setup NUT in netserver mode on debian wheezy with two APC UPS units connected to it by usb. lsusb identifies the units as Smart-UPS 1000 and Smart-UPS C1500. It appears these do not use the smart protocol and usbhid-ups is the correct driver to use.<br><br></div><div>System: Debian wheezy with stock version of nut<br>  (Version: 2.6.4-2.3+deb7u1)<br></div><br>Everything works rather well, except that the cgi-interface does not report input/output voltages and load for the C 1500 unit. <br>upsc also reports these values only for model  1000, not for 1500. Battery charge is and runtime are reported.<br><br>Is this a limitation of the driver, or is there way to get these data?<br><br></div>Thanks<br><br>Selva<br></div>