<div dir="ltr"><div>Any comments please? Not reading input/output voltages is fine with me but it would be useful to read out the output load. Also I want to be sure that other critical parameters like runtime are being read correctly.<br><br></div><div>Could anyone using Smart-UPS C1500 with USB cable please share their experience?<br></div><div><br></div>Thanks.<br></div><div class="gmail_extra"><br><div class="gmail_quote">On Sat, Nov 8, 2014 at 6:12 PM, Selva Nair <span dir="ltr"><<a href="mailto:selva.nair@gmail.com" target="_blank">selva.nair@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div dir="ltr"><div><div><div>Hi,<br><br></div>I have setup NUT in netserver mode on debian wheezy with two APC UPS units connected to it by usb. lsusb identifies the units as Smart-UPS 1000 and Smart-UPS C1500. It appears these do not use the smart protocol and usbhid-ups is the correct driver to use.<br><br></div><div>System: Debian wheezy with stock version of nut<br>  (Version: 2.6.4-2.3+deb7u1)<br></div><br>Everything works rather well, except that the cgi-interface does not report input/output voltages and load for the C 1500 unit. <br>upsc also reports these values only for model  1000, not for 1500. Battery charge is and runtime are reported.<br><br>Is this a limitation of the driver, or is there way to get these data?<br><br></div>Thanks<span class="HOEnZb"><font color="#888888"><br><br>Selva<br></font></span></div>
</blockquote></div><br></div>