[sane-devel] HP ScanJet 5100C problem

[bsaylor@Macalester.edu]

I have an HP 5100C parallel port scanner that I'm trying to get working.
I installed the ppscsi driver, and scanimage recognizes the device, but it
won't complete a scan.

I run scanimage with the command

scanimage -d hp:/dev/sg0 > testscan

Then X freezes for a few seconds while the scanner makes noises, then the
noises stop and X unfreezes, and after a few more seconds, scanimage
returns with the message:

scanimage: sane_read: Error during device I/O

Here is the relevant part of /var/log/messages:

Aug  4 01:48:28 kuching kernel: epst.0: epst 0.92 (0.92), Shuttle EPST at
0x378  mode 0 (Nybble) dly 0 nice 0 sg 0
Aug  4 01:48:28 kuching kernel: scsi0 : epst
Aug  4 01:48:28 kuching kernel:   Vendor: HP        Model: C5190A
Rev: 3740
Aug  4 01:48:28 kuching kernel:   Type:   Processor
ANSI SCSI revision: 02
Aug  4 01:48:28 kuching kernel: Attached scsi generic sg0 at scsi0,
channel 0, id 0, lun 0,  type 3
Aug  4 01:49:10 kuching kernel: epst.0: PDMA done timeout, bs=31 cb=6
db=32768 bu=1 sg=0 rd=1 lp=31 pe=0 cc=922
Aug  4 01:49:10 kuching kernel: epst.0: Arbitration failure, bs=31 cb=0
db=32768 bu=0 sg=0 rd=1 lp=0 pe=0 cc=923
Aug  4 01:49:51 kuching kernel: epst.0: Bus reset

It could be possible that this is a hardware problem.  I got the scanner
for free and was told about a minor glitch that sounded hardware-related.

Thanks,
Ben