[sane-devel] HP4c & Buslogic BT-958

[Steven Lembark]

-- Marcel Pol <mpol@gmx.net>

> On Sat, 24 Nov 2001 01:01:10 -0600
> Steven Lembark <lembark@wrkhors.com> wrote:
>
>> > Having just read it again myself, from the rpm,
> sane-backends-1.0.5-4
>> >
>> >  BusLogic BT958
>> >                      To configure the BusLogic card, you may need
>> >                      to follow these instructions (contributed by
>> >                      Jeremy <jeremy@xxedgexx.com>): During  boot,
>> >                      when your BusLogic adapter is being initial­
>> >                      ized, press Ctrl-B to  enter  your  BusLogic
>> >                      adapter  setup.   Choose  the  address which
>> >                      your BusLogic  containing  your  scanner  is
>> >                      located.  Choose  ``SCSI  Device  Configura­
>> >                      tion''.  Choose ``Scan SCSI  Bus''.   Choose
>> >                      whatever  SCSI id that contains your scanner
>> >                      and then choose ``View/Modify SCSI  configu­
>> >                      ration''.     Change    ``Negotiation''   to
>> >                      ``async''  and  change   ``Disconnect''   to
>> >                      ``off''.  Press  Esc,  save,  and  Esc again
>> >                      until you are asked to reboot.
>>
>> Double checked the BT-948 config, re-ran scanimage -L w/
>> debugging turned on. Still no luck (see attached). The
>> sane-find-scanner quickly identifies the device as my
>> scanner; it's scanimage that keeps blowing up.
>
> You did try it also with disconnect set to default, instead to off?

Both.

--
Steven Lembark                               2930 W. Palmer
Workhorse Computing                       Chicago, IL 60647
                                            +1 800 762 1582