[sane-devel] Problem installing new HP5400 backend

[Thomas Soumarmon]

Hi Robe,

Maybe you did not indicate in dll.conf that it should load hp5400 backend=
 ?
edit /usr/local/etc/sane.d/dll.conf or /etc/sane.d/dll.conf=20
and on a new line add : hp5400=20

Note that direct load of backend (e.g. with -d hp5400) has not been teste=
d=20
yet.

Let us know if it works.

Le Vendredi 28 F=E9vrier 2003 07:15, Rob Male a =E9crit :
> Hello,
> I have been trying to install the new HP5400 backend for my HP5470c on
> Redhat8.0. (but with no luck)
>
> I downloaded and installed sane-backends-1.0.11 and sane-find-scanner
> recognizes the scanner, however scanimage -L reports "No scanners were
> identified"
>
> I downloaded the HP5400 backend and modified the paths in the Makefile
> before doing a make install.
> I made no changes to the hp5400.conf file
>
> sane-find-scanner returns:-
> "found USB scanner (vendor=3D0x03f0, product=3D0x1105) at /dev/usb/scan=
ner0
>   # Your USB scanner was detected. It may or may not be supported by
>   # SANE. Try scanimage -L and read the backend's manpage."
>
> cat on /proc/bus/usb/devices   returns:-
> P:  Vendor=3D03f0 ProdID=3D1105 Rev=3D 0.00
> S:  Manufacturer=3DHewlett-Packard
> S:  Product=3DHP Scanjet 5400C Series
>
> I added the following line to  /etc/rc.d/rc.local
> modprobe scanner vendor=3D0x03f0 product=3D0x1105
>
> /usr/local/etc/sane.d/hp.conf has only 2 lines:-
> /dev/usb/scanner0
> option connect-device
>
> Any suggestion on what to do now would be greatly appreciated as I have
> no idea where to start.
>
> Regards Rob Male
>
>
> _______________________________________________
> Sane-devel mailing list
> Sane-devel@www.mostang.com
> http://www.mostang.com/mailman/listinfo/sane-devel