[sane-devel] Re: scanner not recognised part IIHello again,

[Paul Frisson]

Hello again :-(

About SCSI, I checked with   dmesg | more

which answered this among others :

scsi1: <fdomain> No BIOS; using scsi id 7
scsi1: <fdomain> TMC-36C70 (PCI bus) chip at 0xe400 irq 11
scsi1 : Future Domain 16-bit SCSI Driver Version 5.50
  Vendor: EPSON     Model: SCANNER GT-5000   Rev: 1.07
  Type:   Processor                          ANSI SCSI revision: 01
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0
sr0: scsi3-mmc drive: 32x/32x writer cd/rw xa/form2 cdda tray
Attached scsi generic sg1 at scsi1, channel 0, id 6, lun 0,  type 3
scsi : 1 host left.

So there is a scanner recognised, and the fdomain driver (the one needed fo=
r=20
the AHA-2920) seems to be there at least at boot time, I suppose.

What's next ?

Thank you again for your help, I'm beginning to feel more at ease in linux.

PF




Le Dimanche 29 F=E9vrier 2004 21:11, Karl Heinz Kremer a =E9crit :
> The CD-R shows up as SCSI device because the CD burning software can
> only
> work with SCSI devices. You are using the ide2scsi pseudo SCSI adapter
> for
> this. As you can see, it does not see the scanner. THis means that it's
> not
> a Sane problem, but a problem with the SCSI system (cabling, driver,
> adapter,
> termination...). Did you configure your SCSI controller?