[sane-devel] how to work GT-S620(Perfection V30) on ARM?

Ryosuke kojima raspy at mbf.nifty.com
Sat Nov 21 13:22:35 UTC 2009

thanks for the information.

I changed few lines Epjitsu backend for gt-s620 and tested it.
Initlializing(Firmware transportation and initializing on the scanner) 
only works.

this scanner's basic commands (Ex:checking status) are same as Epjitsu one,
but other various commands seem different.. it's a hard way.

m. allan noah さんは書きました:
> The epkowa driver supports this scanner, but uses a precompiled binary
> module which is only availible for x86, IIRC. Unfortunately, this
> machine seems to use a different protocol from other Epson machines,
> and is not supported by epson or epson2 drivers. The epjitsu driver
> could perhaps be modified to support the V30, but it would take some
> serious development effort.
> allan
> On Wed, Nov 18, 2009 at 8:07 AM, Ryosuke kojima <raspy at mbf.nifty.com> wrote:
>> Hi All,
>> i'm trying to work GT-S620(Perfection V30) on ARM netbook(Sharp Netwalker).
>> I tried Image Scan and Epson2 driver, but I can't work it.
>> I want to work it for my scanner camera. is there any ideas or suggestions?
>> Regards,
>> Ryosuke Kojima
>> ------
>> http://d.hatena.ne.jp/spyuge/
>> --
>> sane-devel mailing list: sane-devel at lists.alioth.debian.org
>> http://lists.alioth.debian.org/mailman/listinfo/sane-devel
>> Unsubscribe: Send mail with subject "unsubscribe your_password"
>>             to sane-devel-request at lists.alioth.debian.org

More information about the sane-devel mailing list