[sane-devel] Canon LiDE 50 not working on recently installed Debian Lenny

[sjnz at freenet.co.nz]

Hello,
I am a complete newbie using a Dell Latitude laptop. I don't know how to
change preferences etc.
Here is the output I get when going through the online documentation. I
have the correct backend GENESYS installed.

on:~$ sane-find-scanner

  # sane-find-scanner will now attempt to detect your scanner. If the
  # result is different from what you expected, first make sure your
  # scanner is powered up and properly connected to your computer.

  # No SCSI scanners found. If you expected something different, make sure
that
  # you have loaded a kernel SCSI driver for your SCSI adapter.
  # Also you need support for SCSI Generic (sg) in your operating system.
  # If using Linux, try "modprobe sg".

found USB scanner (vendor=0x04a9, product=0x2213, chip=GL841?) at
libusb:004:004
  # Your USB scanner was (probably) detected. It may or may not be
supported by
  # SANE. Try scanimage -L and read the backend's manpage.

  # Not checking for parallel port scanners.

  # Most Scanners connected to the parallel port or other proprietary ports
  # can't be detected by this program.

  # You may want to run this program as root to find all devices. Once you
  # found the scanner devices, be sure to adjust access permissions as
  # necessary.


on:~$ scanimage -L

No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).


on:~$ SANE_DEBUG_DLL=3
on:~$ scanimage -L

No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).


on:~$ SANE_DEBUG_GENESYS=255
on:~$ scanimage -L

No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).


on:~$ SANE_DEBUG_SANEI_SCSI=128
on:~$ scanimage -L

No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).