[sane-devel] Canon LaserBase MF6530

janeks.kamerovskis at silvita.lv janeks.kamerovskis at silvita.lv
Mon Aug 22 21:12:14 UTC 2011


Thanks, a lot! The scanner works now.

I read that those devices was not fully tested - probably I can do some 
tests..., but I never did.

brds



On Tue, 16 Aug 2011 07:56:56 -0400, m. allan noah wrote:
> The MF6500 series was listed as supported in sane-backends version
> 1.0.22. Perhaps you need to upgrade?
>
> allan
>
> On Tue, Aug 16, 2011 at 2:18 AM, Janeks Kamerovskis
> <janeks.kamerovskis at silvita.lv> wrote:
>> Huh, finally found that I need in FAQ:
>>
>> I have Ubuntu Linux 10.10
>>
>> xSane 0.997
>> LinuxBox:~$ sudo scanimage --version
>> scanimage (sane-backends) 1.0.21; backend version 1.0.21
>>
>> Janeks
>>
>>
>> On 2011.08.15. 17:10, m. allan noah wrote:
>>>
>>> what version of sane-backends are you using?
>>>
>>> allan
>>>
>>> On Mon, Aug 15, 2011 at 9:44 AM, Janeks Kamerovskis
>>> <janeks.kamerovskis at silvita.lv>  wrote:
>>>>
>>>> LinuxBox:~$ sudo scanimage -L
>>>> device `pixma:04A92686_1666LEuH0000' is a CANON Canon imageClass 
>>>> MF6500
>>>> multi-function peripheral
>>>>
>>>>
>>>> Janeks
>>>>
>>>> On 2011.08.15. 15:53, m. allan noah wrote:
>>>>>
>>>>> What is the output of this command:
>>>>>
>>>>> scanimage -L
>>>>>
>>>>> allan
>>>>>
>>>>> On Mon, Aug 15, 2011 at 8:37 AM, Janeks Kamerovskis
>>>>> <janeks.kamerovskis at silvita.lv>    wrote:
>>>>>>
>>>>>> Hi!
>>>>>>
>>>>>> Could it be possible to force the device above do the scanning 
>>>>>> job.
>>>>>> It works as a printer pretty well, except it does not like that 
>>>>>> printer
>>>>>> is
>>>>>> on before system. And probably could not wake up the device 
>>>>>> after it
>>>>>> was
>>>>>> in
>>>>>> sleep mode.
>>>>>>
>>>>>> As scanner it is visible and I can connect them, but when 
>>>>>> starting a
>>>>>> scan
>>>>>> (preview) it looks like it is woking (act like copying a page), 
>>>>>> but
>>>>>> then
>>>>>> the
>>>>>> device and SANE software hangs.
>>>>>>
>>>>>> brgrds and looking forward
>>>>>> Janeks
>>>>>>
>>>>>> P.S. I can do some diagnostics on command line with some advice.
>>>>>>
>>>>>> --
>>>>>> sane-devel mailing list: sane-devel at lists.alioth.debian.org
>>>>>> 
>>>>>> http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/sane-devel
>>>>>> Unsubscribe: Send mail with subject "unsubscribe your_password"
>>>>>>            to sane-devel-request at lists.alioth.debian.org
>>>>>>
>>>>>
>>>>
>>>
>>>
>>
>>




More information about the sane-devel mailing list