[sane-devel] LIDE 60. configure scanning prefs?

[Ben Green]

Hello Stef,

The main objective for me is that the scan head always gives the same data - this way I can adjust the light coming onto the scan head. I have done this successfully with an older model Lide under plustec and it worked fine - but only after the calibration was bypassed..


Best

Ben



On 11 Feb 2011, at 20:58, stef wrote:

> Le Friday 11 February 2011 21:46:26 m. allan noah, vous avez écrit :
>> I did a bit of digging in the source, and it appears that you could
>> set GENESYS_FLAG_NO_CALIBRATION in the Lide60 entry in
>> backend/genesys_devices.c (along with removing the existing
>> calibration flags), and rebuild sane-backends. That should bypass the
>> calibration code.
>> 
>> allan
>> 
> 
> 	Hello,
> 
> 	you are right, there will be no calibration at all. Including shading 
> calibration, which may be a problem for the quality of the scans.
> 
> Regards,
> 	Stef