<html><body style="word-wrap: break-word; -webkit-nbsp-mode: space; -webkit-line-break: after-white-space; "><div>Hi</div><div>I'm trying to configure various actions inside my Lide 60 such as analogue gain, tinkering with the calibration and the crop area that it scans with. </div><div><br></div><div>The backend seems to have been abandoned on the support front - scanning is no problem, worked first time - its just this .conf file that i cannot drive? is there a list of commands I can feed into the .config file? like lamp on/off, red gain +3 ??? i'm afraid i dont speak Genesys?</div><div><br></div><div>I have done this with some earlier LIDEs that worked with the plustec backend - these were quite straightforward - i could open the SANE prefs and turn calibration on/off, change gain and crop just by changing some zeros and ones.. however this genesys backend has only a list of scanners and their model/product addresses - I don't know what commands to put into the .conf file.</div><div><br></div><div>I'm using SANE: mac10.6:</div><div><br></div><div> TWAIN SANE Interface 2.9 binary <a href="http://www.ellert.se/twain-sane/">http://www.ellert.se/twain-sane/</a> SANE Preference Pane 0.9 binary <a href="http://www.ellert.se/twain-sane/">http://www.ellert.se/twain-sane/</a> SANE backends <a href="http://www.sane-project.org/">http://www.sane-project.org/</a> libusb 0.1.13 beta 2009-09-10 binary <a href="http://libusb.sourceforge.net/">http://libusb.sourceforge.net/</a> </div><div><br></div><div><br></div><div>Any Help is Much Appreciated..</div><div><br></div><div><br></div><div>Thnaks</div><div><br></div><div><br></div><div>Ben</div></body></html>