<div dir="ltr"><div><div><div><div><div><div><div><div><div>Hello,<br><br></div>i like to setup scanbd with my Canon MG6250. scanbd -f works and reacts on pressing scanner buttons.<br><br></div>Now i like to use scanimage on this machine. If i load scand and scan over the net backend it works. But if i try to start scanbd and setup scanbm in xinetd, scanbd will not interruped.<br>
<br></div>Then i tryed to send to send a signal:<br><br></div>kill -s SIGUSR1 interrupts the scanbd. kill -s SIGUSR2 restarts the polling.<br><br></div>But scanbm -d -t0 --signal -a scan does not interrup the scanbd.<br><br>
</div>I can't enable the dbus service on my ubuntu 12.10, because it haven't systemd.<br><br></div>Here the output of scanbm and the syslog part.<br><br></div>regards Matthias<br><br></div><div>Terminal:<br><br>sudo scanbm --signal -d -t0 -a scan<br>
</div><div><br></div>Syslog:<br><br>Feb  7 17:20:10 matze-Satellite-C660 saned[6115]: saned (AF-indep+IPv6) from sane-backends 1.0.24git starting up<br>Feb  7 17:20:10 matze-Satellite-C660 saned[6115]: check_host: getpeername failed: Socket operation on non-socket<br>
Feb  7 17:20:10 matze-Satellite-C660 saned[6115]: init: access by host [error] denied<br>Feb  7 17:20:10 matze-Satellite-C660 saned[6115]: saned exiting<br><br></div>