[sane-devel] hp scanjet 2200c

Görkem Güngör nem65 at hacettepe.edu.tr
Sun Jan 5 16:39:16 GMT 2003


hi,
i did't load the sane frontend. 

i unloaded and loaded the module, but it is 
still the same response. i wasn't using the
xterm, but nothing changes if i use it or not.

my kernel version is 2.4.18-19.7.x 
and sane-backends 1.0.9

the sane-find-scanner output is:

found USB scanner (vendor=0x03f0, product=0x0605) at /dev/usb/scanner0
  # Your USB scanner was detected. It may or may not be supported by
  # SANE. Try scanimage -L and read the backend's manpage.

but plustek has my scanner listed and it is loaded, so it
should be supported. 

bye. 

On Sat, 4 Jan 2003, Henning Meier-Geinitz wrote:

> Hi,
> 
> On Sat, Jan 04, 2003 at 03:49:56PM +0200, Görkem Güngör wrote:
> > i have a hp scanjet 2200c scanner, i installed
> > sane with plustek backend, both the kernel and
> > sane-find-scanner detects the scanner, but
> > i get an error:
> > 
> > scanner.c: open_scanner(0): Scanner device is already open
> 
> That message usually just means what it says. So maybe you have
> already a frontend running on a different xterm? 
> 
> To make sure that no other backend make trouble, comment out
> everything but plustek in dll.conf. Unload/reload the scanner module.
> 
> > the scanner is new, i haven't seen it work yet. but i suppose
> > if the kernel can detect vendor & product ids, it should be
> > working.
> 
> Which kernel version and sane-backends version do you use?
> 
> Bye,
>   Henning
> _______________________________________________
> Sane-devel mailing list
> Sane-devel at www.mostang.com
> http://www.mostang.com/mailman/listinfo/sane-devel
> 




More information about the sane-devel mailing list