[sane-devel] can not initialize sane when linux system booting up

Frank Frank at snapafun.co.nz
Mon May 19 13:40:55 BST 2003


On Monday 19 May 2003 12:14 pm, T.M.Thanh wrote:
Hi

I have just installed mdk 9.1 and have no problem. I do however 
ensure the the scanner is turned on at boot up, a lesson 
learned when using mdk9.0 and having to configure this scanner 
myself in the first place.

I note in your message that you might be in the habit of turning 
the scanner on later. Maybe try this first before trying 
anything else.

Good luck for now

> Hi folks,
>
> Sane can't initialize my Acer 640 BU Scanner when linux
> system booting up (I use RED HAT 9 and Mandrake 9.1). If I
> want to run my scanner on Linux, I have to turn it on and
> restart my system to Windows then reboot system to Linux and
> run XSane. Or I have to turn it on and boot into Windows then
> reboot into Linux. That's my workarround :-) Could any body
> help me ?

-- 
Regards

Frank

025853824

Either big or small, a challenge requires the same commitment to 
resolve.




More information about the sane-devel mailing list